use this surface for 24 hours after refinishing (at room temperature).
When removing the masking paper, peel it off slowly in an upward
and outward direction. Use particular care around the drain
NOT lay soap, bottles or any object on the finished
surface, put them on a shampoo
Be sure that your faucets ARE
DRY every evening, drain shower pipes, then close
tightly. If you have a leak, take care immediately.
A. Make sure there is no standing water in the tub after
the rest of the water has drained.
The tub should be completely dry a couple of hours after
Clean and finish regularly during the curing period with
soap and sponge (this is called
surface conditioning) to remove any dust that might have
A. In older tubs, you may encounter gouges or surface imperfections
known as pinholes.
Although little can be done for those, it will cause no
harm to the tub.
IN ORDER TO RETAIN THE FACTORY-LIKE FINISH OF A REFINISHED
DO NOT use an abrasive
cleaner, which will scratch the surface. ONLY clean after
use with Scrubbing Bubbles made by Dow, Fantastic, 409,
Lysol Tub and Tile Cleaner and
Soft Scrub without bleach (blue label). It is extremely
important to clean the surface
AFTER EACH USE, as this will prevent soap scum build up.
DO NOT drop sharp objects
on the finish, which may cause it to chip. Contact your
REFINISHER immediately for repairs if this should occur
(within 1-2 weeks of accident).
If peeling, bubbling, cracking or fading should occur, it
is the responsibility of the customer
to properly notify the REFINISHER within 1-2 weeks of occurrence.
All leaky faucets must be repaired to protect the finish
against the eroding action of
dripping water, which may cause the finish to crack and
wear out prematurely.
Destruction of the finish may occur through improper use
of acid bearing compounds
(drain openers, tile grout cleaners). All chemicals (cosmetics,
bleach, hair dyes,
perfumes...) must be kept away from the finish, for it may
stain or mar the finish.
A. Not responsible non-factory glazed bathroom tile floor.
DO NOT use a rubber mat,
ESPECIALLY WITH SUCTION CUPS.
Most mats will produce
a reaction with the finish when subjected to hot water.
Contact your REFINISHER for
a non-rubber SLIP PROOF BATH
MAT (if available).
A. Remove mat after each use.
Caulk line between tub and tile must be properly sealed
at all times. It is the
responsibility of the customer to recaulk the tub unless
previously agreed upon
and written down on the work order prior to starting job.
In certain cases, cork
around drain area must be properly sealed at all times.
Rusted or recessed areas
particularly around drain are not guaranteed.
A. Soap dishes, towel bars and toothbrush holders are not
Remember, if you treat your new
surface with respect, clean it regularly and follow items 1-9,
your fixture will stay shiny, bright and give you many years
of trouble free service.
THIS REFINISHING WORK IS GUARANTEED
FOR 5 YEAR AGAINST BUBBLING, FADING,
OR GRAZING. THIS GURANTEE DOES NOT APPLY TO CHIPPING OR TO CUSTOMER
OF ITEM 1-9. SUCH REPAIRS WILL BE THE RESPONSIBILITY OF THE
CUSTOMER & NOT THE REFINISHER AND REGLAZING MAKES NO GUARANTEE
THAT SURFACE BADLY MARRED, GAUGED
OR INTENDED DUE TO YEAR OF USE FROM EROSION OF WATER, ACID OR
CHEMICLE WILL BE RESTORED TO ORIGINAL CONDITION OF THE TUB.